EasyManuals Logo

Xerox DocuPrint 3055 Quick Reference Guide

Xerox DocuPrint 3055
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
56 5 Troubleshooting
Output is partially blanked-out.
Vertical white streaks appear
on output.
The paper is not appropriate for the printer. Load appropriate paper.
Refer to
“Supported Paper” (P. 34)
The paper is damp. Load fresh paper.
The print cartridge or feed rolls are not installed correctly.
Correctly install the print cartridge or feed rolls.
The printer's interior may not be clean. Clean the interior of the printer.
Dew condensation may have formed in the printer.
On the control panel, set the interval that the printer switches to the Sleep mode to
more than 60 minutes, and let the printer stand with its power on. After about an hour,
the condensation disappears due to the heat inside the printer.
The print cartridge or fuser unit is damaged or deteriorated. The print cartridge or fuser
unit may need replacement depending on its condition. Contact our Customer Support
Center or your dealers.
White patches appear on output.
Toner scatters around images.
Change the [Paper Type] setting and try printing again. For example, if [Paper Type] is
set to [Heavyweight 1], try changing it to [Heavyweight 2].
Texts are smeared.
The paper is not appropriate for the printer. Load appropriate paper.
Refer to
“Supported Paper” (P. 34)
The paper is damp. Load fresh paper.
Dew condensation may have formed in the printer.
On the control panel, set the interval that the printer switches to the Sleep mode to
more than 60 minutes, and let the printer stand with its power on. After about an hour,
the condensation disappears due to the heat inside the printer.
Texts are garbled.
Output printed is not the same
as the original data displayed
on your computer screen.
The data was printed using a font that does not come standard with the printer. Check
the font used by the application. If using PostScript (optional), download fonts as
necessary.
Isn’t the printer set to substitute TrueType fonts with the built-in fonts?
Change the printing method of TrueType fonts under the [Detailed Settings] tab > [Font
Settings] on your print driver.
Refer to
Online help for the print driver
Symptom Cause/Remedy

Table of Contents

Other manuals for Xerox DocuPrint 3055

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox DocuPrint 3055 and is the answer not in the manual?

Xerox DocuPrint 3055 Specifications

General IconGeneral
BrandXerox
ModelDocuPrint 3055
CategoryPrinter
LanguageEnglish

Related product manuals