40. Install the white plastic alignment plate and the screw, on
the fill plug side.
41. Install the white plastic alignment plate on the gear side.
42. Install the bearing onto the developer roller shaft of the fill
plug side.
43. Install the small spring as shown onto the developer roller
shaft.
XEROX PHASER 3600 • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
