Xerox Phaser 3010 User Manual (English)

Other manuals for Xerox Phaser 3010

Manual&Nbsp;4 pages

Installation Guide2 pages

Questions and Answers:

K
Kevin ShannonJul 26, 2025
What to do if my Xerox Phaser 3010 does not print?
- Q
  quinnangelaJul 27, 2025
  If your Xerox Printer isn't printing, it could be in Energy Saver mode. Try pushing the control panel button. Also, check the error indicator: if it's on and the Ready Indicator is off, the printer is out of toner and you should replace the toner cartridge; if the Ready Indicator is flashing, load paper into the Main Tray. If the error persists, contact your Xerox representative. If both control panel indicators are off, turn off the printer, make sure the power cord is correctly plugged in, and turn it back on.
B
Brooke PetersenAug 1, 2025
How to fix a Xerox Phaser 3010 Printer that does not turn on?
- C
  Corey EspinozaAug 1, 2025
  If your Xerox Printer isn't turning on, first ensure that the power switch is turned on. Next, check that the power cord is securely plugged into the outlet. If it still doesn't work, test the outlet with another appliance or try a different outlet. Finally, verify that the outlet's voltage and frequency match the printer's specifications.
E
Elizabeth FarrellAug 7, 2025
Why does my Xerox Phaser 3010 reset or turn off frequently?
- J
  Jaclyn MuellerAug 7, 2025
  If your Xerox Printer frequently resets or turns off, ensure the power cord is correctly plugged into both the printer and the outlet. Also, it could be a system error, so try turning the printer off and on again. If that doesn't work, the printer might be connected to an uninterruptible power supply, in which case you should connect it to a suitable outlet. Lastly, avoid sharing a power strip with other high-power devices; plug the printer directly into the outlet.
R
Rebecca AlexanderAug 13, 2025
Why is my Xerox Phaser 3010 making unusual noises?
- G
  George ScottAug 13, 2025
  If your Xerox Printer is making unusual noises, it could be due to an obstruction or debris inside. Turn off the printer and try to remove any obstructions. If you cannot remove it, contact your Xerox representative.
M
Michael MayAug 19, 2025
What to do if condensation has formed inside my Xerox Phaser 3010 Printer?
- E
  Edward DouglasSep 12, 2025
  If condensation has formed inside your Xerox Printer, it may have been sitting in a cold room. Allow the printer to operate for several hours at room temperature. Alternatively, the humidity in the room might be too high; reduce the humidity or move the printer to a location within the operating specifications.

Xerox Phaser 3010 Specifications

General

Print Technology	Laser
Print Speed	20 ppm
Paper Capacity	150 sheets
Connectivity	USB 2.0
Processor	150 MHz
Memory	64 MB
Output Capacity	100 sheets
Printer Type	Monochrome Laser Printer
Duplex Printing	Manual
Maximum Paper Size	A4
Toner Yield	1, 000 pages
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	30, 000 pages
First Page Out Time	8 seconds
Media Sizes Supported	A4, Letter, Legal
Operating System Compatibility	Windows, Mac