Xerox Phaser 3010 User Manual

Troubleshooting
Phaser 3010/3040 Printer 53
User Guide
Adjusting the Altitude
Use Adjust Altitude to adjust the altitude of the printer to obtain optimal printing results. If the altitude
setting is incorrect, it can cause print-quality problems. Adjust the altitude to match that of the location
where the printer is installed.
To adjust the altitude:
1. Launch the Printer Setting Utility and select the Printer Maintenance tab.
2. Click Adjust Altitude.
3. Select the altitude range to match that of the location where the printer is installed.
4. Click Apply New Settings.
Cleaning the Developer
Clean Developer runs the developer motor and stirs the toner in the toner cartridge. Use Clean Developer
to clean toner from a cartridge just before changing it or to refresh the toner after replacing a
toner cartridge.
1. Launch the Printer Setting Utility and select the Diagnosis tab.
2. Click Clean Developer.
3. Click Start.

Xerox Phaser 3010 Specifications

General

Print Technology	Laser
Print Speed	20 ppm
Paper Capacity	150 sheets
Connectivity	USB 2.0
Processor	150 MHz
Memory	64 MB
Output Capacity	100 sheets
Printer Type	Monochrome Laser Printer
Duplex Printing	Manual
Maximum Paper Size	A4
Toner Yield	1, 000 pages
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	30, 000 pages
First Page Out Time	8 seconds
Media Sizes Supported	A4, Letter, Legal
Operating System Compatibility	Windows, Mac