Xerox Phaser 3010 - Error Codes

Troubleshooting
Phaser 3010/3040 Printer 55
User Guide
Error Codes
Error Code
Status
Solutions
—
Ready
Normal operation.
—
Downloading print.
Warming up.
Waking from Energy Saver Sleep
mode.
Printing when the toner is low.
Normal operation.
—
In Energy Saver mode.
Normal operation.
Out of paper.
Load paper, then press the button on the
control panel.
Waiting for manual 2-sided printing.
Remove the paper from the output tray
and reload it into the paper tray.
See Loading Paper for Manual 2-Sided
Printing on page 22.
Paper is jammed.
Clear the paper jam.
See Clearing Paper Jams on page 41.
The wrong size paper is loaded.
Load the correct paper.
Canceling the print job.
Wait for the print job to cancel.
Non-volatile memory is initializing.
Do not turn off the printer.
Note: Interrupting the initialization of
the non-volatile memory can damage
the printer.
—
Toner cartridge is empty.
Replace the toner cartridge.
The rear cover is open.
Close the rear cover.
Print engine error.
Turn off the printer, then turn it on again.
—
The printer has a fatal error.
Turn off the printer, then turn it on again.
Contact your Xerox representative.