Xerox Phaser 3010 User Manual

Troubleshooting
38 Phaser 3010/3040 Printer
User Guide
Condensation has Formed Inside the Printer
Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is located
in a warm room. Condensation can form in a printer after it has been sitting in a cold room that is
heated quickly.
Probable Causes
Solutions
The printer has been sitting in a cold room.
Allow the printer to operate for several hours at room temperature.
The relative humidity of the room is too high.
Reduce the humidity in the room.
Move the printer to a location where the temperature and
relative humidity are within the operating specifications.

Xerox Phaser 3010 Specifications

General

Print Technology	Laser
Print Speed	20 ppm
Paper Capacity	150 sheets
Connectivity	USB 2.0
Processor	150 MHz
Memory	64 MB
Output Capacity	100 sheets
Printer Type	Monochrome Laser Printer
Duplex Printing	Manual
Maximum Paper Size	A4
Toner Yield	1, 000 pages
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	30, 000 pages
First Page Out Time	8 seconds
Media Sizes Supported	A4, Letter, Legal
Operating System Compatibility	Windows, Mac