Xerox Phaser 860 Networking Setup Guide

Networking Setup Guide 25
Printer Management
Intelligent Ready
Intelligent Ready is an automated system that monitors the printer’s usage and warms up
the printer when you are most likely to need it. You can turn Intelligent Ready on or off
from the printer’s front panel. CentreWare IS provides full control of the printer’s
automatic warm-up and standby settings.
Enabling and Disabling Intelligent Ready From the Front Panel
To turn Intelligent Ready mode on or off, on the front panel:
1. With Menus highlighted, press the OK key.
2. Scroll to Printer Setup Menu by pressing the Scroll Up or Scroll Down key.
3. Press the OK key.
4. Scroll to Intelligent Ready.
5. Press the OK key.
6. Scroll to display either On or Off.
7. Press the OK key.
8. To exit the menu system, scroll to Exit and press the OK key.
Setting up Intelligent Ready Using CentreWare IS
1. Connect to the printer via CentreWare IS (see page 23).
2. On the right side of the page, click Properties.
3. In the General group, click Warm-up.
4. Follow the instructions on the page to set up Intelligent Ready or standby settings.
5. Click Save Changes to save your changes.

Xerox Phaser 860 Specifications

General

Brand	Xerox
Model	Phaser 860
Category	Printer
Language	English