Xerox Phaser 860 Networking Setup Guide

Networking Setup Guide 31
Network Protocols
Network Protocols
Determining Enabled Protocols
All protocols can be enabled and disabled. The Configuration Page displays which
protocols are enabled. If a protocol is enabled, the field for that protocol lists the current
parameters. If the protocol is disabled, the field for that protocol contains an entry reading
Off.
Disabling and Enabling Protocols
After your network configuration is complete, you may want to disable protocols that you
are not using to avoid unnecessary network traffic. There are four ways to disable
protocols:
■
Use the printer’s front panel — see page 32.
■
Using CentreWare DP — In NetWare environments, you can use CentreWare DP. See
the CentreWare DP Setup and User Guide.
■
Using CentreWare IS — see page 32.
With a TCP/IP connection and a World Wide Web browser, you can use CentreWare
IS.
■
Using PostScript Utility Files
Send the appropriate PostScript utility file to the printer. See the ReadMe files on the
printer’s CD-ROM. The PC ReadMe file is in the UTILS directory; the Macintosh
ReadMe file is in the Network Utilities folder.
You can enable protocols by the same procedure. Just select the command to enable a
protocol rather than disable it.

Xerox Phaser 860 Specifications

General

Brand	Xerox
Model	Phaser 860
Category	Printer
Language	English