Suggested solutionsProblem
The system requires approximately 2 minutes when switching
print modes in order to make any necessary adjustments for
the next print job, including color-to-color registration, density,
charge levels, bias levels, or other adjustments.
• The system has two print modes selectable at the print
server:
- 4 Color Mode (CMYK: Cyan, Magenta, Yellow, Black)
- Black and White Mode Only
• If the next print job is switching print modes, for example
from black-only to 4-color, the system requires approxim-
ately 2 minutes to make any necessary adjustments.
• During this time, the touch screen displays the “Adjusting
Image Quality” message.
• The next job begins printing once the system completes
its adjustments.
Other information to remember includes:
• From a cold start (power on or power saver), system takes
less than 5 minutes to start printing.
• From standby mode, system usually takes less than 1
minute to start printing.
The press is taking longer than
one minute before printing the
next job.
Check the application or print driver settings on whether non-
standard fonts are being used for printing.
Text prints incorrectly (text is
corrupted).
• Access the Stock Library Manager and check the paper
settings for the tray.
• Check the print server settings.
• Check that the paper is loaded correctly as either SEF or
LEF and this matches the paper settings programmed at
the print server.
Trays do not recognize the media.
Xerox
®
Versant
®
2100 Press10-4
User Guide
Problem Solving
To Next Page
Loading...
