Suggested solutionsProblem
Potential impacts:
• Ensure that the correct paper weight and paper type are
selected.
• The mass of dry ink (toner) coverage on the print output
- the greater the dry ink / toner mass, the greater the paper
curl.
• The paper weight and whether or not it is coated or un-
coated.
• The humidity conditions at the press.
• You can sometimes minimize curl problems by flipping the
paper over in the tray. If excessive curl is still present, use
a heavier paper.
• To ensure continuous production, empty the output device
when the output approaches the maximum amount that
the device can hold; refer to the specifications for that
output device for output limit amount.
• An attempt to print on thicker paper or on paper stock
that is less sensitive to moisture.
Paper curl can be adjusted in the following ways:
• If the Interface Module is attached, use the manual decurl
buttons on the Interface Module’s control panel. Refer to
the section, Interface Module.
• If the Standard / Booklet Maker Finisher is attached, use
the manual decurl buttons on the finisher. Refer to the
section, Standard / Booklet Maker Finisher.
• Use the Advanced Stock Setup feature (Paper Curl Correc-
tion option); At the print server, refer to the Stock Library
Manager Online Help for more information.
Excessive paper curl.
• Replace the fuser assembly with one that supports the
specific paper width for the current print job. Refer to Fuser
Paper Width Information
• Cancel the current print job and continue with the print
job by resubmitting from the print server.
Note
Recommend not overriding. This mismatch could prematurely
damage the fuser.
Unable to print with current fuser
assembly. Output paper width
does not match the installed
fuser.
• If the fault is a paper jam, ensure that any paper is re-
moved from the area and that there are no hidden or small
pieces of paper left behind.
• Reboot the press by pressing the On / Off button at the
Control Panel.
Message will not clear.
10-7Xerox
®
Versant
®
2100 Press
User Guide
Problem Solving
To Next Page
Loading...
