Fault Codes - Oversized High Capacity Feeder (Trays 8 and 9)
Replacing the OHCF Feed Rolls for the OHCF (Trays 8 and 9)
The OHCF feed rolls should be replaced every 300,000 prints or when experiencing
frequent multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the OHCF feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Retard Roll
Note
After you replace all of the feed rolls, contact your system administrator who will reset
the High Frequency Service Item (HFSI) usage counter for these CRU components to
zero (0).
1. Pull open the top tray of the OHCF to access the feed components.
2. Notice the feed roll compartment on the right side panel of the drawer.
11-5Xerox
®
Versant
®
2100 Press
User Guide
Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)
To Next Page
Loading...
