Xerox Versant 2100 - Loading Media in the OHCF (Trays 6 and 7)

Some wrinkling or embossing may occur when printing on envelopes. Successful envelope
printing depends on the quality and construction of the envelopes. Try another envelope
brand if problems occur.
Loading Media in the OHCF (Trays 6 and
7)
Note
Each feeder tray has a stock loading label. When loading media into the tray, refer to
the labels on the inside panel of the feeder tray for the correct orientation of that stock
type.
Note
It is recommended that you use the Bypass (Tray 5) to feed envelopes. However, if you
use Trays 6 or 7, C5 and #10 envelopes must be fed SEF with the Postcard Bracket
installed. Stack height is limited to 200 envelopes.
Postcard Bracket
The Postcard bracket is delivered with the OHCF from manufacturing. The Postcard
bracket allows you to print on smaller size media without requiring post-processing
cutting or sorting. The Postcard bracket specifically accommodates 4 x 6 in. (101.6 x
152.4 mm) SEF media.
Using the Postcard Bracket
Use the following procedure for installing and using the Postcard Bracket when printing
on smaller media (4 x 6 in. / 101.6 x 152.4 mm).
With the Postcard Bracket installed, you can print envelopes from Trays 6 and 7. The
stack height is up to 200 envelopes.
1. Slowly open one of the paper trays until it stops and remove the paper.
4-9Xerox
®
Versant
®
2100 Press
User Guide
Paper and Other Media