e) Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
f) Select the item (HCF) that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the High Frequency Service Item
(HFSI) to 0.
14. Exit administrator mode by pressing the Log In / Out button on the Control Panel.
When prompted, select Logout.
Related Topics:
Fault Codes - Oversized High Capacity Feeder (Trays 6 and 7)
Replacing a Dry Ink / Toner Cartridge
Note
The dry ink / toner cartridge can be replaced while a job is printing.
Note
After you replace a dry ink / toner cartridge, the system automatically resets the High
Frequency Service Item (HFSI) usage counter for this CRU to zero (0). Check the
Consumables Supplies screen to verify the reset and new status.
1. Open the Dry Ink / Toner cover, located just above the press front door / cover.
2. Lay paper on the floor before removing the cartridge. This will allow any excess dry
ink / toner to fall on the paper.
3. Grasp the handle of the dry ink / toner cartridge matching the color indicated in the
message.
4. Remove the dry ink / toner cartridge by slowly and gently pulling it straight out. While
pulling out, hold the bottom of the cartridge with your other hand to give it support.
5. Dispose of or recycle the cartridge per your local authorities and regulations.
In the United States, also refer to the Electronic Industries Alliance website:
www.eiae.org. For more information about Xerox environmental programs, go to
www.xerox.com/environment.
6. Remove the new dry ink / toner cartridge from its packaging.
9-11Xerox
®
Versant
®
2100 Press
User Guide
Maintenance
To Next Page
Loading...
