3. Grasp the handle of the Dry Ink / Toner Waste Bottle and pull it halfway out of the
press.
4. Grip the handle with one hand and slowly begin to remove the waste bottle from the
press.
Caution
Never use a vacuum cleaner when cleaning up spilled dry ink / toner. Use a broom or
a cloth moistened with a neutral detergent.
5. Since the waste bottle may be heavy, support the underside of the bottle with your
other hand as you continue pulling it out from the press.
6. Use both hand to place the old used Dry Ink / Toner Waste Bottle into the provided
plastic bag.
7. Remove a new, empty waste bottle from the packaging.
8. Hold the center part on the top of a new bottle and insert it evenly and gently into
the press until it comes to a stop.
9. Close the front cover door.
Replacing a Drum Cartridge
Other than replacing a drum cartridge after 348,000 prints, you may need to replace a
drum cartridge if it is damaged by light or you are experiencing spots and streaks on
your output.
Note
All four Drum cartridges are interchangeable.
Note
After replacing the drum cartridge, the system automatically resets the High Frequency
Service Item (HFSI) usuage counter of this CRU component to zero (0). Check the
Consumables screen for the reset and new status.
9-13Xerox
®
Versant
®
2100 Press
User Guide
Maintenance
To Next Page
Loading...
