10 getting started guide
2 Confirm that an IP address has been allocated and that it is an appropriate IP address for
your network.
NOTE: If the IP address starts with 169.xxx.xxx.xxx, the DHCP server has not properly
allocated an address or DHCP is not enabled on your network. Contact your network
administrator for assistance.
Network Setup Using a Static IP Address
Before you begin, obtain the following information from your network administrator:
• IP Address
• Gateway Address
• Subnet Mask
• DNS Server Address
1 Press the Access button on the Control Panel, enter the
Administrator’s passcode [1111] and select Enter.
2 On the screen select Go to Tools > Connectivity and
Network Setup > Network Setup > TCP/IP Options.
3 Select HTTP and Enable. Select Save.
4 Select TCP/IP Settings.
5 Touch the Dynamic Addressing button. By default, DHCP
will be selected. Select Disabled to disable DHCP and
touch Save.
6 Select Name/Address. Enter the Host Name, by touching the Keyboard symbol. Enter the
IP Address by touching each box and entering the number using the Numeric Keypad.
Select Save.
7 Select Subnet and Gateway. Enter the Subnet Mask and IP Gateway. Select Save.
8 If you do not wish to configure DNS settings proceed to the next step. If you wish to
configure DNS settings select the DNS Configuration button. Enter the Domain Name and
the Preferred DNS Server address. Select Save.
9 The static IP address is now set. Select Exit Tools.
To Next Page
Loading...
Need help?
General
