Xerox WorkCentre PE114e - Exit Roller; LSU

5-10
Disassembly and Reassembly
Service Manual
5.7 Exit Roller
1. Before you remove the Exit Roller you should remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Scanner Ass’y (see page 5-4)
- Middle Cover (see page 5-6)
2. Remove the white Exit Gear, and release a bearing
clip at one end then remove the shaft and rollers as
shown below.
Exit Gear
Bearing
Exit Roller
1
2
5.8 LSU
1. Before you remove the LSU you should remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Scanner Ass’y (see page 5-4)
- Middle Cover (see page 5-6)
2. Unplug 2 connector from the LSU.
3. Unplug 4 screws and take the LSU out.
LSU