5-11
Disassembly and Reassembly
Service Manual
5.9 Fan
1. Before you remove the Fan you should remove:
- Rear Cover (see page 5-2)
- Right Side Cover (see page 5-3)
2. Unplug the connector from the SMPS and remove 1
screw. Then take out the Fan.
5.10 Drive Ass’y
1. Before you remove the Drive Ass’y, you should
remove:
- Rear Cover (see page 5-2)
- Left Side Cover (see page 5-3)
2. Remove the 6 screws from the Drive Ass’y.
Note when re-fitting the motor Drive Ass’y tighten the
screws in the order that they are numbered on the Motor
Drive Ass’y base plate.
3. Unplug 1 connector from the Drive Ass'y.
To Next Page
Loading...
