5-12
Disassembly and Reassembly
Service Manual
5.11 Engine Shield Ass’y
1. Before you remove the Fuser, you should remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Fuser Connector (see page 5-7)
2. Remove the 14 screws securing the Engine Shield
Ass'y and unplug the all connectors. Then remove the
Engine Shield Ass'y.
5.12 Main PBA
1. Before you remove the Main PBA, you should
remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Fuser Connector (see page 5-7)
- Engine Shield Ass'y (see page 5-11)
2. Unplug 1 connector and remove 5 screws from the
Main PBA. Then lift the Main PBA out as shown
below.
To Next Page
Loading...
