Xiaomi 1S - How to Install; Installing the Ribbon; Loading 3 Sticky-backed Photo Paper

2
How to Install
1
Installing the Ribbon
Open the ribbon compartment.
2
Insert a new ribbon and make
sure it is secured.
3
Close the ribbon compartment.
90°
Note: Li the red lever above the ribbon
to remove the ribbon.
Loading 3" Sticky-backed Photo Paper
1
Pull the paper tray holder open.
2
Rotate the holder vertically till it
snaps to the paper tray boom.
3
Open the paper tray cover.
4
Load the 3" sticky-backed photo
paper into the slot of the 3" paper
holder with the glossy side facing
up.
Note: The printer may not feed paper if
more than 10 sheets of 3" sticky-backed
photo paper are loaded.
Note: Make sure the 3" paper holder
is in the paper tray.