Installing and Disassembling
2. Installing and Disassembling the Propellers
Installing: Install the propeller marked with orange on the sha marked with orange and
press into place.
Disassembling: Tightly grip the machine with one hand while gripping the propeller sha
with the other as you forcefully pull the sha upwards, which will allow you to remove the
propeller.
Note: Illustration for an installation to the orange marking
Orange Marking
Aention: To avoid any loosening of interfaces caused by wear, do not frequently disassemble
the propeller. If the propeller has been dismantled many times, before use, you should check
the firmness of its connection with the motor shas to ensure safe use.
To Next Page
Loading...
