Xiaomi Robot Vacuum E10 User Manual

09
How to Use
If only vacuuming function is needed, please remove the
mop pad holder.
Start Vacuuming & Mopping
1. Press and hold the release buon to remove the 2-in-1 dust compartment
with water tank. Open the plug, fill the tank with clean water, and then
refasten the plug. Install the 2-in-1 dust compartment with water tank onto
the robot vacuum until it firmly clicks into place.
3. Install the 2-in-1 dust compartment with water tank into the robot vacuum.
Press the buon to start vacuuming and mopping.
2. Before using the vacuuming & mopping function, dampen the mop pad and
wring it out and then install it onto the mop pad holder.
Install the mop pad holder to the 2-in-1 dust compartment with water tank,
as illustrated.
CAUTIONS:
Please remove the 2-in-1 dust compartment with water tank before adding water. Do not
add liquids such as hot water, detergent, or disinfectant to prevent damaging the robot
vacuum.
Due to production testing, the 2-in-1 dust compartment with water tank may have water
stains, which is normal.
ş š
CAUTION: Remove the 2-in-1 dust compartment with water tank and pour out the leover
water in a timely manner aer a mopping task has been completed. Then clean and dry the
mop pad to prevent odor and mildew.
Open the plug and
add water.
Release Buon
Š
ş Š
Ţ
Pull the holder out as
illustrated

Xiaomi Robot Vacuum E10 Specifications

General

Suction Power	4000 Pa
Battery Capacity	2600 mAh
Dustbin Capacity	400 ml
Dimensions	325 x 325 x 80 mm
Noise Level	65 dB
Compatible Floor Types	Hardwood, Tile, Carpet
Runtime	110 minutes
Charging Time	4 hours
Connectivity	Wi-Fi
Control	App, Voice
Water Tank Capacity	200 ml