Xinje ZG3 Series - Page 66

SFD1160
Pulse parameters setting
Bit 0：logic of pulse output
0：positive logic;
1：negative logic , default is 0
Bit 1：logic of pulse direction
0：positive logic;
1：negative logic , default is 0
Bit 8：pulse unit
0：pulse number;
1：pulse equivalent, default is 0
Public
parameters
PULS
E_3
SFD1161
SFD1162
Low 16 bits of pulse number per
circle
SFD1163
High 16 bits of pulse number per
circle
SFD1164
Low 16 bits of pulse equivalent
per circle
SFD1165
High 16 bits of pulse equivalent
per circle
SFD1166
Pulse direction terminal
Assign the number of termimal Y,
0xFF for no terminal
SFD1167
Direction delay time
Default 20，unit：ms
SFD1168
Positive compensation of gear
gap
Negative compensation will also
use this data when gear gap
negative compensation =0
SFD1169
Negative compensation of gear
gap
SFD1170
Low 16 bits of Electrical origin
position
SFD1171
High 16 bits of Electrical origin
position
SFD1172
Mechanical back to origin
parameter setting
Bit0：Switch state setting of near
point, 0 ： Normally ON ；
1Normally OFF
SFD1173
Terminal setting of near point
signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1174
Z phase terminal setting
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1175
Limit terminal setting
Bit7~bit0：Assign limit 1 number
of terminal X, 0Xff for not
terminal
Bit15~bit8 ： Assign limit 2
number of terminal X, 0Xff for
not terminal