Xinje ZG3 Series - Page 76

SFD1550
Pulse parameters setting
Bit 0：logic of pulse output
0：positive logic;
1：negative logic , default is 0
Bit 1：logic of pulse direction
0：positive logic;
1：negative logic , default is 0
Bit 8：pulse unit
0：pulse number;
1：pulse equivalent, default is 0
Public
parameters
PULS
E_6
SFD1551
SFD1552
Low 16 bits of pulse number per
circle
SFD1553
High 16 bits of pulse number per
circle
SFD1554
Low 16 bits of pulse equivalent
per circle
SFD1555
High 16 bits of pulse equivalent
per circle
SFD1556
Pulse direction terminal
Assign the number of terminal Y,
0xFF for no terminal
SFD1557
Direction delay time
Default 20，unit：ms
SFD1558
Positive compensation of gear
gap
Negative compensation will also
use this data when gear gap
negative compensation =0
SFD1559
Negative compensation of gear
gap
SFD1560
Low 16 bits of Electrical origin
position
SFD1561
High 16 bits of Electrical origin
position
SFD1562
Mechanical back to origin
parameter setting
Bit0：Switch state setting of near
point, 0 ： Normally ON ；
1Normally OFF
SFD1563
Terminal setting of near point
signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1564
Z phase terminal setting
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1565
Limit terminal setting
Bit7~bit0：Assign limit 1 number
of terminal X, 0Xff for not
terminal
Bit15~bit8 ： Assign limit 2
number of terminal X, 0Xff for
not terminal