XK A800 - Troubleshooting

Troubleshooting guide
Situation
Reason
Countermeasure
After power, aircraft lights
flash and manipulate
without response
Remote control and aircraft
code unsuccessfully
Re-match code according to
steps of matching code
showed in page 7
After er on, gyroscope
be am work bg re 4
motor starts
Power on the plane when the
throfile stick is not in the lowest
position or throftle trim is too high
Pull throttle stick in the
correct position, power on
again after the throttle trim
is back to the midpoint
After power on, the plane The battery is low, speed Charge the battery or replace
does not turn when pushing | controller enters shutdown the charged battery
the throttle, steering lights | protection
work properly
Individual rudder servo block | Steering gear teethto be less | Replace the faulty steering
when manipulating the joystick|
Powerful vibration when the | Blade deformation, untight Replace problematic blades
motor is running position between hoop and
motor, or hoop broken, motor
and paddles, secure the
paddles, and secure the
seat loose motor motints
Model raw fly, can notfly | Rudder is notin the center 1. Tum the rudder back to center
straigh position, gyroscope accumulated| 2. G pe be reset ta 0 and
error is big justed according to Page 7
Plane fly but gyroscope
has no reaction, can not
repair normally
Gyroscope is ouf of control
Replace the receiver
The plane is still in operation
when the plane lands or the
throttle stick is in the lowest
position
During flight, mistakenly raised
throttle tnm
Turn the throttle trim back to
the mid-point
...1 0_