14
The electric bilge pump (1) in the aft of the boat is posi-
tioned in the fore part of the engine compartment in the
middle of the boat
The fore bilge pump (2) is positioned in the technical
space and can be accessed by opening the service
hatch under the helmsman’s position. The electric bilge
pumps are equipped with a float which triggers them
automatically if there is water in the bilge space. The
electric pumps have direct supply switches, which allow
the pump to come on even if the power is switched o in
the boat. The pumps can also be used manually via the
switches (3) on the switchboard.
The boat’s bilge pumps are equipped with an indicator
light that notifies the helmsman if any water has
accumulated in the bilge. The light is connected to the
bilge pump, which ensures that it comes on when the
pump switches itself on.
The indicator light is positioned in the steering console’s
switchboard.
The manual bilge pump (4) is meant to be used in case
the electric bilge pump is out of use. The pump can be
operated by opening the lid and attaching the separate
handle located next to the pump to the bilge pump.
Regularly check all bilge pump inlet and remove any
debris.
NOTE !
Regularly check the operation of the bilge pump. If you
notice that the bilge pump does not operate properly,
remove any debris from the pump inlet and contact
your XO dealer if necessary
NOTE !
Check the amount of bilge water by emptying the
bilge manually with the spring-loaded switch located
on the switch panel every time before use. It is recom-
mended to have at least one bucket or bailer on board
To Next Page
Loading...
