— 6 —
Recycle
Return your used electronic products, batteries, and packa-
ging materials to dedicated collection points. This way you
help prevent uncontrolled waste disposal and promote the
recycling of materials.
Before First Use
To Be Performed By a Trained Healthcare
Professional Only!
Initial Setup
1. Glasses will arrive from the factory turned off. To turn
them on use a fine flat head screwdriver and insert it in the
larger hole on inner right side of the glasses (switch hole,
marked 8 in Amblyz™ Glasses Overview). Gently rotate
the screwdriver in the clockwise direction until you will feel
a click (both lenses will continuously go from transparent to
occluded, at two second intervals).
2. Connect the glasses to a USB charger or port. Both the
LED and both lenses should flash at an accelerating rate,
eventually stop flashing and stay transparent.
3. Press the button located in the small hole (button hole,
marked 9 in Amblyz™ Glasses Overview) on inner right
side of the glasses using a pin with a blunt tip. Hold the
button pressed for ten seconds or until the LED and left
lens start flashing.
4. At this stage you must choose the lens that will be
occluded. Take special care when setting the correct eye
to be occluded. Once set, reversing your choice will be
impossible.
5. If you need to occlude the left eye – press the
button for ten more seconds otherwise proceed to the next
step. The left lens and the LED should now blink faster.
To Next Page
Loading...
