37
7. FUEL TANK & ELECTRONICS
RADIO PLATE MULTI-FLEX™
ALU RADIO PLATE MULTI-FLEX™ BUSHING
NO FLEX FLEX
INITIAL SETTING
Recommended for softer tires or tires with
additive to improve stability and make the car
easier to drive.
Recommended for spec hard tires to improve
in-corner steering.
90°~95°
902306
SH M3x6
902310
SH M3x10
Attach steering linkage
to servo saver.
NT1 has the option to set the flex setting also by tightening and loosening
the screws that connect the radio plate with the upper arm holder. By
removing one of the 2 set of screws, in-corner steering is improved.
IMPORTANT
Remove only 1 screw per side: either the front or the rear screw. Repeat
for the other side. Never drive with all four screws removed.
Servo arm must be perpendicular to linkage
when servo is in neutral.
DETAIL
DETAIL
DETAIL
When the bushing is used, the radio plate does
not flex around the servo saver.
When the bushing is not used, the radio plate
flexes around the servo saver.
Use the screw to tight the servo saver.
3x10mm
3x6mm
3x6mm
To Next Page
Loading...
Need help?
General
