38
7. FUEL TANK & ELECTRONICS
DETAIL
902306
SH M3x6
902308
SH M3x8
907206
SP M2x6
903306
SFH M3x6
➊
➋
➌
➌
Use an appropriate receiver battery pack.
The NT1 accommodates standard 5-cell
receiver packs or optional micro-size packs.
Use tape to mount the receiver battery
pack to the lower holder.
The battery holder has a direct effect on chassis flex and car
weight.
Use the GRAPHITE battery plate to slightly stiffen the chassis
flex for better stability.
Use the BRASS battery plate to stiffen the chassis flex and
increase weight. Recommended for high-traction tracks or soft
tires (or tires with additive) to reduce traction roll and make
the car easier to drive.
#336156
BRASS BATTERY PLATE FOR LIPO BATTERIES-100g - V2
#336155
GRAPHITE BATTERY PLATE - V2
Antenna
Receiver
(NOT INCLUDED)
Battery (NOT INCLUDED)
Route servo and transponder leads into
box and seal with silicone sealant
If the receiver box has 2
different-size openings for
cable entry (narrow and
wider), cut away the tab for the
appropriate opening to allow
the cables to fit properly.
Personal Transponder
(NOT INCLUDED)
3x8mm
3x8mm
3x8mm
3x8mm
2x6mm
3x6mm
To Next Page
Loading...
Need help?
General
