Xray T4'21 - FRONT SUSPENSION ADJUSTMENTS; ECCENTRIC BUSHINGS

17
903306
SFH M3x6
303129
SHIM 3x6x1
903306
SFH M3x6
1mm
1mm
Marked
“FR”
FRONT SUSPENSION
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER.
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY front alu lower suspension holders provide even greater range of adjustment for the front suspension. Using different combinations of eccentric bushings, fine adjustment of front
anti-squat, front kick-up, front toe-in, front roll center, and front track-width can be obtained. For more information about the influence of front anti-dive, front kick-up, front toe-in, front
roll center and front track-width on car handling, please refer to HUDY Set-up Book.
Marked
“FF”
All possible mounting
alternatives of eccentric bushings
FRONT SUSPENSION
NOTE
ORIENTATION
NOTE
ORIENTATION
INITIAL SETTING
FOR ASPHALT
INITIAL SETTING
FOR CARPET
ECCENTRIC BUSHINGS
0.5º
1.0º
INITIAL SETTING
FOR ASPHALT
INITIAL SETTING
FOR CARPET
ECCENTRIC BUSHINGS
0.5º
1.0º
NOTE ORIENTATION
3. FRONT & REAR SUSPENSION
#307217
TITANIUM SUSPENSION
PIVOT PIN (2)
It is extremely important that the arms move freely
on the pivot pins. If they do not, use the Arm Reamer
(3.0mm) to slightly resize the holes in the arms.
L=R
#107633 HUDY Arm Reamer 3.0mm