14
TOE-IN
TRACK-WIDTH
WHEELBASE
ROLL CENTER
ANTI-SQUAT
PRO-SQUAT
1mm
903306
SFH M3x6
NOTE
ORIENTATION
903306
SFH M3x6
INITIAL SETTING
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY rear alu lower suspension holders provide even greater range of adjustment for the rear suspension. Using different combinations of eccentric bushings, fine adjustment of rear
squat, rear toe-in, rear roll center, and rear track-width can be obtained. For more information about the influence of rear squat, rear toe-in, rear roll center and rear track-width on car
handling, please refer to HUDY Set-up Book (#209100).
Marked
“RR”
REAR SUSPENSION
Marked
“FR”
FRONT SUSPENSION
#303731 ALU LOWER 2-PIECE
SUSPENSION 0.25 ECCENTRIC
HOLDER STAND
INITIAL
SETTING
COMPOSITE ECCENTRIC
BUSHINGS
INITIAL SETTING
COMPOSITE ECCENTRIC
BUSHINGS
Do not use INNER positions.
Available positions
COMPOSITE ECCENTRIC
BUSHINGS
NOTE
ORIENTATION
NOTE
ORIENTATION
303129
SHIM 3x6x1
1mm
L=R
#307217
TITANIUM SUSPENSION
PIVOT PIN (2)
L=R
#107633 HUDY
Arm Reamer 3.0mm
It is extremely important that the arms move freely
on the pivot pins. If they do not, use the Arm Reamer
(3.0mm) to slightly resize the holes in the arms.
NOTE ORIENTATION
3. FRONT & REAR SUSPENSION
To Next Page
Loading...
