15
903306
SFH M3x6
303129
SHIM 3x6x1
TOE-IN
TRACK-WIDTH
WHEELBASE
ROLL CENTER
ANTI-DIVE
KICK-UP
All possible mounting
alternatives of eccentric bushings
1mm
1mm
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER.
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY front alu lower suspension holders provide even greater range of adjustment for the
front suspension. Using different combinations of eccentric bushings, fine adjustment of front
anti-squat, front kick-up, front toe-in, front roll center, and front track-width can be obtained.
For more information about the influence of front anti-dive, front kick-up, front toe-in, front roll
center and front track-width on car handling, please refer to HUDY Set-up Book.
Marked
“FF”
FRONT SUSPENSION
INITIAL SETTING
COMPOSITE ECCENTRIC
BUSHINGS
INITIAL SETTING
COMPOSITE ECCENTRIC
BUSHINGS
NOTE
ORIENTATION
NOTE
ORIENTATION
INITIAL SETTING
3. FRONT & REAR SUSPENSION
#307217
TITANIUM SUSPENSION
PIVOT PIN (2)
It is extremely important that the arms move freely
on the pivot pins. If they do not, use the Arm Reamer
(3.0mm) to slightly resize the holes in the arms.
L=R
#107633 HUDY
Arm Reamer 3.0mm
To Next Page
Loading...
