17
940508
BB 5x8x2.5
930306
BB 3x6x2.5
903308
SFH M3x8
2x
L=R
303129
SHIM 3x6x1
approximately 47mm
NOTE
ORIENTATION
6mm THREAD
NOTE
ORIENTATION
STEERING LINKS
SERVO LINK
Adjust servo link to fit your servo
65.4mm
INITIAL SETTING (1mm shim)
1mm 1mm 1mm 2mm
To change Ackermann angle, use 2 identical
shims (of same thickness) between the alu
steering plate and ball ends.
2x
2x
L=R
THREAD
THREAD
BEARING OIL
(HUDY #106230)
OIL
Install the pivot balls with Professional
Multi Tool (HUDY #183011)
#302612-O
ALU ADJ. TURNBUCKLE M3
L/R 39mm ORANGE - SWISS
7075 T6 (2)
#302610
ADJ. TURNBUCKLE L/R 40mm
HUDY SPRING STEEL (2)
3x6x2.5mm
5x8x2.5mm
Tighten the screws gently but fully, and then loosen 1/3
turn so the composite dual-servo saver moves freely.
➊ tighten fully
➋ loosen 1/3 ccw
➌ check free movement
(120° CCW)
4. STEERING
#302525
ALU DUAL SERVO SAVER ARM
We recommend using the aluminum dual-servo saver arms
when better steering response is needed. Also recommended
for asphalt tracks.
THREAD
THREAD
OIL
NOTE
ORIENTATION
#302548
ALU STEERING PLATE 8MM FOR DUAL SERVO SAVER
Optional 8mm steering plate reduces steering response and
increases cornering speed. Recommended for big open tracks,
but also on technical tracks with many chicanes as it decreases
over-steering and increases stability of the car in chicanes.
When using 8mm steering plate, remove
a bit of material from the ball joints so
they do not touch each other.
FREE
MOVEMENT
To Next Page
Loading...
