35
GEARING ADJUSTMENT
903306
SFH M3x6
902308
SH M3x8
For improved weight balance and for more space for electronics, we recommend using a narrow, light servo.
90°
Adjust the motor so the pinion meshes with the
spur gear properly. Make sure the gear mesh is
not too tight.
There should be a small amount of play between
the teeth of the pinion gear and the spur gear.
DETAIL
When adjusting steering on the radio, we recommend
using full steering adjustment in order to get the best
steering from the car. It is important to verify that the
steering block does not touch the C-hub; that would
lead to chassis tweak due to extra servo strain.
IMPORTANT!
From Servo
DETAIL
Attach servo arm to servo output shaft
using screw from servo. Servo saver must
be perpendicular to chassis when servo
is in neutral.
Motor & Pinion
(NOT INCLUDED)
(#901302) 3x2.5mm set screw
(NOT INCLUDED)
Some motors do not have a chamfer on
the motor housing. If your motor does
not have a chamfer on the housing and
you want to use a small pinion, the motor
may touch the top deck. Use a moto-
tool with grinding bit or file to remove
material from the top deck; this will
allow the motor to be moved closer to the
spur gear or you can shim out the motor
by using #303122-O (3x6x1mm) shims.
1mm
1mm
The information about optional forward
servo mount is at the end of manual.
#306410
ALU FAN MOUNT
#293110 HUDY BRUSHLESS RC FAN 30MM
#293111 HUDY BRUSHLESS RC FAN 40MM
7. FINAL ASSEMBLY
To Next Page
Loading...
