Xray XT4 - MOTOR AND GEAR MESH SETUP

41
8. FINAL ASSEMBLY
902310
SH M3x10
NOTE
ORIENTATION
Adjust the motor so the pinion meshes with the spur gear properly. Make sure the gear mesh is not too tight.
There should be a small amount of play between the teeth of the pinion gear and the spur gear.
➊ Adjust gear mesh
➋ Tighten the screw
NOTE
ORIENTATION
➊
➊
➊
➋
Pinion
(NOT INCLUDED)
➊ Loosen the screw
➋ Insert motor into the bulkhead
➊
➋
NOTE
PINIONS
#365718 18T / 48P
#365719 19T / 48P
#365720 20T / 48P
#365721 21T / 48P
#365722 22T / 48P
#365723 23T / 48P
#365724 24T / 48P
#365725 25T / 48P
#365726 26T / 48P
#365727 27T / 48P
#365728 28T / 48P
#365729 29T / 48P
#365730 30T / 48P
#365731 31T / 48P
#365732 32T / 48P
#365733 33T / 48P
#365734 34T / 48P
#365735 35T / 48P
#365736 36T / 48P
#365737 37T / 48P
#365738 38T / 48P