40
Rev. 1 24/01/2020
The software can be downloaded for free from the web site (pay attention to the correct installation of the
drivers).
• https://www.giorgiobormac.com/it/download-software_Download.htm.
• Connect the USB cable inside each package to the USB port on the top panel of the instrument and the
other end to a COM port on the computer.
• Use the USB cable supplied with the instrument only.
• Start the program and then switch on the instrument.
• Wait for connection to be established (the connection data are shown at the bottom left of the display).
• Functions
• Download: the data saved in the instrumental memory are downloaded to a PC and displayed in the
table for processing.
• M+: instantaneous acquisition of a value (equivalent to the manual Data Logger option).
• Logger: automatic acquisition with set frequency.
• Empty: emptying the data in the table. If the password is active, it will be requested.
• Export to Excel / Export to PDF: export to PDF and Excel of all the data in the table, of graphs,
calibration reports and instrumental information.
• Save to file / Open from file: saving the data in the table and possibility to reload them in order to
process them or continue recording.
• Select the language: set the interface language (Eng – Ita – Deu – Esp – Fra – Cze).
• Table / Graph: how to display the acquired data. The graphs are divided by parameter and can be
printed separately.
Reproduction of
display for real-
time
measurements
for each
parameter
Logger
Functions
Visualization of acquired
data in table or graph
Connection data and instrument
information
To Next Page
Loading...
Need help?
General
