4. Pull back the SCL170A and always
ensure the 2 tires against the step facade.
And the operator should stand at the right
place (usually 2-3 steps higher than the
tire). The “up/down” switches on the
top of the control panel is “up”.
5. Press the point-touch button to run
the climbing motor, the climbing S arm will
lift the SCL170A to the next step, so the
operator just needs to hold the button and
keep balance to prevent tipping.
Release the point-touch button, the
motor will stop.
1. The “up/down” switches on
the top of the control panel is
“down”.
Lift up the brake rod to lose the
brake.
To Next Page
Loading...
