10
ERG400 Rower
Handlebar, Seat, Pedals & Console
4
Hardware Step 4
1. Remove the pre-assembled Rubber Foot (82) and Phillips Head Screw
(83) from both sides of the end of the aluminum track.
2. Slide the Seat (30) onto the Aluminum Track (2). Be sure of the correct
orientation of the Seat (30).
3. Implement one of Axle Bushings (91) on the Pedal Stopper Shaft (58)
going through the Main frame (1) and cover with Lever Sleeve (59).
4. Pierce the Pedal Axle (8) through the Main frame (1) and put on two
Axle Bushings (73) and Pedals (72) on both ends (make sure pedals are
correct for each side) and use Combination M5 Allen Wrench & Phillips
Head Screw Driver (97) to tighten the shaft with two Flat Washers(69)
and two Button Head Socket Bolts(92).
Parts Pre-Assembled
on Machine.
To Next Page
Loading...
