11
ERG400 Rower
1. Cover the aluminum track with Aluminum End Cover (29) by using Com-
bination M5 Allen Wrench & Phillips Head Screw Driver (97) to tighten
with two Phillips Head Screws (45).
2. Secure two Rubber Foots(82) at both ends of the aluminum track with
two Phillips Head Screws(83).
3. Secure Protective Cap (84) at of the aluminum track with two Phillips
Head Screws (45).
Hardware Step 5
Stabilizer Tubes & Wheel Covers
5
Parts Pre-Assembled
on Machine.
To Next Page
Loading...
