10
FB160 Folding Bike
KEY FUNCTIONS
BUTTONS
MODE - Push down for selecting functions.
SET - To Set the consumer movement of time, distance, calories and hand pulse.
RESET -For resetting consumer movement of time, distance, calories and hand pulse.
FUNCTIONS AND OPERATIONS
SCAN: Press the MODE button until SCAN appears, the monitor will rotate through the 6
functions: time, speed, distance, calorie, odometer, and pulse. Each display will be held 6
seconds.
TIME: Shows your elapsed workout time. Press the MODE button until “TIME” appears, press
SET button to set target time.
SPEED: Display current speed.
DISTANCE: Count the distance from exercise start to end. The maximum value is 999.99
miles. Press the MODE button until “DISTANCE” appears, press SET button to set target
distance.
CALORIE: Count the total calories from exercise start to end. Press the MODE button until
“CALORIE” appears, press SET button to set target calories.
ODOMETER: Monitor will display the total accumulated distance.
PULSE RATE: Press the MODE button until “PULSE” appears. Press SET button to set
target heart rate. The heart rate range can be set anywhere from 40 - 240 BPM.
Before measuring your pulse rate, please place your palms of the hands on both of the
contact pads. The monitor will show your current heart rate in beats per minute(BPM) on the
LCD after 6~7 seconds.
During the process of pulse measurement, the measurement value may be higher than
the actual pulse rate during the rst 2~3 seconds of reading, after which it will stabilize and
display a more accurate reading. The heart rate measurement value is not intended to be and
should not be used as the basis for medical treatment.
NOTE
• If the display is faint or shows no gures, please replace the batteries.
• The monitor will automatically shut off if there is no signal received after 4 minutes.
To Next Page
Loading...
Need help?
General
