Xtralis VESDA E-Series - Page 153

ASPIRE Software
VESDA Student Workbook 7-9
Set preferences
Click the Project Defaults tab and configure the
following:
• Interface: Advanced
• Enforced Limit: NFPA
• Hole Sizes: 5/64”; 1/8”; 9/64”; 5/32”; 11/64”;
13/64”; 1/4”
Set preferences
Click the General tab and configure the following:
• Select Show capillary relative direction
• Select Save reports in project file folder
• Set Tooltip delay (ms): 10000
• Click Save