4. Pump Run Under MODE1/MODE2
MODE 1/MODE2 Introduction
MODE 1 MODE 2
16 hours running cycle 24 hours running cycle
Stage
Start
Time
Running
Hour
Default
Speed
Quick
Start
Button
Stage
Start
Time
Running
Hour
Default
Speed
Quick
Start
Button
S1
6:00
AM
3
(adjustable)
2400RPM
(adjustable)
CLEAN S1
12:00
PM
6 (adjustable)
1500RPM
(adjustable)
ECO
S2
9:00
AM
5
(adjustable)
1500RPM
(adjustable)
ECO S2
6:00
AM
3 (adjustable)
2400RPM
(adjustable)
CLEAN
S3
6:00
PM
3
(adjustable)
2400RPM
(adjustable)
CLEAN S3
9:00
AM
9 (adjustable)
1500RPM
(adjustable)
ECO
S4
9:00
PM
5
(adjustable)
1500RPM
(adjustable)
ECO S4
PM
6 (adjustable)
2400RPM
(adjustable)
CLEAN
ECO CLEAN BOOST
8
Indicator Light
ECO
CLEAN
BOOST
1000-2400RPM
DEFAULT:1500
2400-2850RPM
DEFAULT:2400
2850-3450RPM
DEFAULT:3250
4.2 How to Set and Change Specification of MODE1/MODE2
1) Make sure STOP button is pressed before set up, and pump is not working. Press MENU, LED
screen will display the current time (time will not count during set-up), use arrow buttons to adjust
the time. LEFT and RIGHT to move the cursor one digit, and UP and DOWN to increase or
decrease one digit.
(Remarks: 0:00-11:59 is one cycle). For example, the current time is 6:00 and AM light
is shining,
when change the time after 11:59, the time change to 0:00, PM light will shine.
2) After time set-up, press ENTER to save and quit. Don't press ENTER if you would like to
continue to change the specification of MODE1 and MODE 2. Press MENU again, the light of
MODE 1 and S1 will shine, screen display 6:00, and AM light is shine. Use arrow buttons to
adjust the time. When the time is over 11:59, PM light will shine, AM light extinguished.
3) Press ENTER to save and quit after start time set-up. To continue and adjust the running hour,
press MENU, then use arrow buttons to increase and decrease running hours. Each press is for 1
hour. Press ENTER to save and quit. Or press MENU to adjust S2/S3/S4, the same adjustment
method as S1.
4) Follow MODE 1's adjustment methods to adjust MODE
2.
5) Could not
change speed using arrow buttons when running
MODE1/MODE2. Can only change the speed of MODE 1 and MODE 2 by pressing CLEAN/ECO/
BOOST, and then use arrow button UP and DOWN to change the RPM. When it is done, the
corresponding speed in MODE 1/MODE 2 will also be changed.
You could do the changes in the right categories. For example, in MODE 1, S1 and S3 is CLEAN,
S2 and S4 is ECO; in MODE 2, S1 and S3 is ECO, S2 and S4 is CLEAN.
5. How to Operate The Pump?
Totally three pre-programmed schedules: Regular Mode ( including ECO; CLEAN; BOOST) and
MODE 1/MODE 2. You can chan
ge the speed in the mode of ECO/CLEAN/BOOST freely.
To Next Page
Loading...
Need help?
General