To Next Page

To Previous Page

Stopping and Running The Pump

3.1 Start The Pump

1) Make sure the pump is connected with power. When power is on, the display screen will display

the time.

2) Press one of ECO/CLEAN/BOOST, the pump will run. The light on the corresponding program

will shine. No matter what program you select, the pump will run on 2850RPM for 5 minutes to

eliminate the air in the pump, so the impeller will not dry grind thus to cause leakage. After high-

speed running, the pump will run the default speed of the selected program.

3.2 Stop The Pump

Press STOP, and the pump will stop. The lights on the screen twinkle.

3.3 Change Pump Running Speed

1) When the pump is running ECO/CLEAN/BOOST, press arrow buttons up or down to change the

speed, each press will change for 50RPM. It will save automatically, no need to press ENTER.

2) Switch ECO/CLEAN/BOOST during pump operation, the pump will not run 5 minutes high speed

again.

3) For MODE 1 and MODE 2, to change speed of S1 and S3, first press CLEAN, if not work, you will

need to stop the pump first. After 5 minutes high speed running, press CLEAN, then press arrow

button to increase or decrease RPM. When press MODE 1 or MODE 2 again to run the pump, S1 and

S3 will run as just selected. To adjust S2 and S4, first press ECO, if not work, you will need to stop the

pump. After 10 minutes high speed running, press ECO, then press arrow button to increase or

decrease RPM . When press MODE 1 or MODE 2

again, S2 and S4 will run as just selected.

NOTE: RPM for S2 and S4 or S1 and S3 are always the same. The default RPM for S1 and S3 is

2400RPM, the adjustable range is 2400 to 2850RPM.

The default RPM for S2 and S4 is 1500RPM.The adjustable range is 1000 to 2400RPM.

3.4 Pump Run Under Pre-programmed Conditions

Pump has three quick start buttons ECO/CLEAN/BOOST, as below

figure. The default speeds are

1500, 2400, 3250RPM respectively.

1) Be sure the pump is power on.

2) Press one of ECO/CLEAN/BOOST buttons, the LED light on

screen will shine.

3) The screen will display STUP (means Start Up! for 1

second, and run 2850RPM for 5 minutes. After 5 minutes, the

pump will run on the selected speed.

XtremepowerUS 75025 User Manual

Questions and Answers: