Need help?Do you have a question about the Xvive U2 and is the answer not in the manual?
General| Type | Wireless Guitar System |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Battery Life | Up to 5 hours |
| Power Source | USB charging |
| Operating Band | 2.4GHz |
| Compatibility | Instruments with 1/4" output jack |
| Battery | Rechargeable lithium-ion |
| Included | Transmitter, Receiver, USB Charging Cable |
| Connectors | 1/4 inch jack |
| Latency | Less than 6ms |
| Dimensions | Transmitter: 2.36" x 1.18" x 0.59" (60mm x 30mm x 15mm); Receiver: 2.36" x 1.18" x 0.59" (60mm x 30mm x 15mm) |
| Weight | Transmitter: 1.06 oz (30g); Receiver: 1.06 oz (30g) |
Device compliance with FCC Part 15, RSS-210, EN standards, and Canadian ICES-003.
Instructions for plugging the transmitter into the guitar and receiver into audio equipment.
Guide to turning on the system and verifying correct channel pairing via LED lights.
How to check if the receiver LED lights indicate a successful connection.
The final step indicating the system is ready for use.
How to use the power switch and understand the LED status for power and battery.
Process for aligning transmitter and receiver channels using the designated button.
Explains the meaning of blue LED flashes for signal status on both units.
Details the use of the USB port for charging the device.
Explains the use of multiple channels for different instruments or interference avoidance.
Highlights the system's ease of use and portability for quick setup.
Describes how to connect a single transmitter to multiple receivers.
Recommendations on positioning the receiver to avoid signal interference.
Details how to select, change, and lock the system's operating channel.
Information on charging the transmitter and receiver using the Y-cable and LED indicators.
Explains what blue LED flashing signifies, such as signal interference.
Guidance on optimal antenna positioning for the strongest signal.
Details supported pickup types and best practices for connecting to instruments.
Clarifies that the USB port is for charging only and does not support firmware upgrades.
To Next Page