3
Typical Beverage Installations
Coffee Cart/Kiosk
The Bottled Water Booster System
may also be placed in a pantry, closet,
cellar or other location where a
grounded electrical outlet is available.
Application
• Designed for dispensing Bottled Water
to coffee machines, beverage dispensers,
vending machines and carts. See diagrams
• For remote locations where mains water
supply is not accessible
• Ideal for under counter installation
Installation and Operation
Installation procedure: See Figure 1
1. Securely mount in a suitable position. If mounting vertically to a wall, ensure that the mounting fixings are
suitable for the product’s wet weight. Ensure that the on / off switch is accessible and that there is sufficient
space above the accumulator tank to access the air valve
2. Pre-charge accumulator tank to 18 PSI (1.2 Bar) per the troubleshooting section
3. Install appropriate adapter onto the universal wall power transformer, plug into grounded electrical outlet
and into the pump module
4. Fill water tank
5. Install suction wand with universal cap seal, float switch and hose assembly
6. Open all faucets and switch appliance(s) on to fill if necessary
7. Turn the ON/OFF switch located on the pump module to the “ON” position to prime pump
8. When water is free of air, turn all faucets off beginning with the faucet closest to the pump
Regular cleaning and sanitizing of the Flojet Bottle Water Booster System is required.
The BW Booster System is only to be used with the power supply provided.
Check accumulator tank pressure every 6 months and adjust as necessary.
Important: Do not operate the pump more than 20 minutes continuously.
To Next Page
Loading...
Need help?
General
