3
ELECTRICAL HAZARD:
NOTICE: Never operate a unit unless safety devices are installed.
Hazard categories
Hazard categories can either fall under hazard levels or let specific symbols replace the ordinary hazard levels
symbols. Electrical hazards are indicated by the following specific symbols:
These are examples of other categories that can occur. They fall under the ordinary hazard levels and may use
complementing symbols:
• Crush hazard • Cutting hazard • Arc flash hazard
User safety
General safety rules
These are safety rules apply:
• Always keep work area clean
• Pay attention to the risks presented by gas and vapors in the work area.
• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards
• Always bear in mind the risk of drowning, electrical accidents and burn injuries
Safety equipment
Use safety equipment according to the company regulations. Use this safety equipment within the work area:
• Hard hat • Gas mask
• Safety goggles, preferably with side shields • Hearing protection
• Protective shoes • First-aid kit
• Protective gloves • Safety devices
Electrical connections
Electrical connections must be made by certified electricians in compliance with all international, national, state
and local regulations. For more information about requirements, see sections dealing specifically with electrical
connections.
Precautions before work
Observe these safety precautions before you work with the product or are in connection with the product:
• Provide a suitable barrier around the work area, for example, a guard rail
• Make sure that all safety guards are in place and secure
• Make sure that you have a clear path of retreat
• Make sure that the product cannot roll or fall over and injure people or damage property
To Next Page
Loading...
Need help?
General
