XYZ Machine Tools
ProTURN SLX 1630 ProtoTRAK SLX CNC Safety, Installation, Service & Parts List Manual
2.2 Uncrating
Carefully remove the protective packaging, paying attention not to scratch, damage,
or mar any parts of the machine.
Remove the cardboard boxes with the PENDANT DISPLAY (handle carefully). The
leveling pads and screws for the machine can be found in the toolbox.
Loosen and remove 4 screws and nuts holding the machine to the wood pallet.
ATTENTION!
Immediately report, in writing, any damages observed at this time that can be attributed to the
transportation or improper handling/moving of the machine.
2.3 Shortages: Inventory Checklist
______Machine (check model and serial number)
______Leveling pads and screws (4 for 1630)
______Pendant Display (24000-4)
______Pendant Cable Cover (24324)
______Toolbox with various tools
______SLX 1630 Safety, Operation & Programming Manual (P/N 24494)
______SLX 1630 ProtoTRAK SLX CNC Safety, Install, Maint, Service & Parts List Manual (P/N
25099)
In case of shortages, contact the representative from whom you purchased the machine.
To Next Page
Loading...
Need help?
General
