FCC Compliance Statement
This equipment complies with the specifications in Part 15 of the FCC Rules.
The following two conditions shall be met during the operation:
(1)This equipment will not cause harmful interference;
(2)The equipment may withstand any external interference,including interference that may cause unexpected
operation.
Note:
The equipment has been tested to meet the limitations of Class B digital equipment in accordance with Part
15 of FCC Rules.These limitations are designed to provide reasonable protection against harmful interference
in residential installation conditions.This equipment produces,uses and radiates RF energy.Failure to install
and use in accordance with the instructions may cause harmful interference to radio
communications.However,it cannot be guaranteed that interference will not occur in a particular installation.If
the equipment does cause harmful interference with radio or television receipt signal,which can be
determined by turning the equipment off or on,the user is encouraged to attempt to eliminate the interference
by one or more of the following measures:
Adjust the direction or position of the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to a socket in another circuit other than the socket in the circuit to which the receiver
is connected.
Consult a dealer or experienced radio/television technician for assistance.
19
To Previous Page
Loading...
