PART 5 Installation Steps
1.Unfold the Kickstand, unfold the stem and
stabilize the scooter.
2. Connect the handlebar to both ends of the
power cable inside the stem, place them
all in the stem, and then install the
handlebar onto the stem.
4. After the assembly is completed, connect
the charger to charge the scooter for
2-3
seconds
to wake up the battery, and then
you can turn on the scooter and start it
after the battery is activated.
3. Lock the screw with the mounting tool
(3mm) in the package.
• Please follow the instructions to install the components. Improper installation may cause
safety risks.
• When installing the handlebar, please set it in the correct angle.
• Fix the scooter and stem during installation to avoid injury caused by tipping.
• Do not turn on the power supply before the installation is completed. When installing
components, please apply appropriate force to avoid component damage or scooter body
failure.
Attention
09
10
To Next Page
Loading...
