Need help?Do you have a question about the Yaesu FRG-7 and is the answer not in the manual?
General| Type | Communications Receiver |
|---|---|
| Modes | AM, SSB, CW |
| Tuning Steps | 1 kHz |
| Selectivity | 2.4 kHz (-6 dB) |
| Audio Output Power | 1.5 W |
| Frequency Range | 150 kHz to 30 MHz |
Lists the integrated circuits, transistors, and diodes used in the receiver.
Explains the power supply options for the FRG-7, including AC, DC, and battery.
Details the antenna connection requirements and the importance of a good ground connection.
Details primary controls like BAND, ATT, TONE, TUNING DIAL, FINE TUNING, VOLUME, and MODE for operation.
Covers indicators (S-METER, LOCK) and secondary controls (LIGHT, POWER, PHONES, RECORD, MHz, PRESELECT).
Details jacks for external speaker, DC power, antenna, and ground connections.
Information on the AC cord, fuse, and battery pack for power supply.
Guides on selecting frequencies and operating the receiver for amateur SSB bands.
Instructions for receiving broadcast signals on AM mode and noise reduction.
Lists the necessary test equipment for maintenance and alignment procedures.
Alignment steps for the RF Unit's passband circuit, balanced mixer, and antenna coils.
Additional alignment steps for the RF Unit's selective filter and lock level controls.
Alignment procedures for the OSC Unit (MHz setting) and IF AF Unit (IF tracking, S-meter, BFO).
To Next Page
