Need help?Do you have a question about the Yaesu FT-200 and is the answer not in the manual?
General| Brand | Yaesu |
|---|---|
| Model | FT-200 |
| Category | Transceiver |
| Language | English |
Detailed explanation of the receiver's signal path and operation.
Detailed explanation of the transmitter's signal path and operation.
Explains signal generation and transmission processes for SSB, AM, and CW.
Describes carrier crystal, bandswitched heterodyne, VFO, calibrator, and AF oscillators.
Details local oscillator mixer and meter circuits.
Describes the circuit providing regulated voltage to oscillators.
Details phone, mic, function, and gain controls.
Explains VFO, calibration, band, and receiver offset tuning controls.
Covers grid tuning, metering, sideband, and PTT/VOX controls.
Details RF, antenna, power supply, accessory, key, and VFO sockets.
Explains rear panel VOX, bias, carrier, and meter adjustment controls.
Step-by-step guide for initial control setup and receiving signal tuning.
Step-by-step instructions for tuning the transmitter output.
Instructions for operating in SSB, CW, and AM modes.
Lists tools, guides regulator adjustment, and VFO alignment.
Covers alignment of heterodyne oscillators, calibrator, and mixer.
Steps for aligning receiver audio, AGC, IF, mixer, and RF amplifier stages.
Procedures for aligning balanced modulator, crystal filter, and driver stage.
Neutralizing and tuning the final amplifier tubes for optimal performance.
Details the FP-200/250 and DC-200/250 external power supplies.
Provides a system overview of the transceiver's functional blocks.
To Next Page
